![]() On the first boot, the user interface can take up to 10 minutes to come up. When execution is finalized riff will exit Riff will detect the board and start the execution ![]() $ sudo add-apt-repository -remove ppa:igloocommunity-maintainers/snowball-toolsĬonnect your board using the OTG USB port (next to power supply port) to $ sudo add-apt-repository ppa:igloocommunity-maintainers/snowball-tools $ linaro-android-media-create -image-file snowball.img -image-size 1500M -dev snowball_emmc -boot 2 -system 2 -userdata 2 $ mkimage -A arm -O linux -T ramdisk -C gzip -a 0 -e 0 -n initramfs -d. $ dd if=uInitrd of=initrd.gz bs=64 skip=1 If you want to be able to boot from the eMMC, you need to modify a few lines If you don't have riff, follow the instructions below to install it. $ sudo linaro-android-media-create -image-file snowball.img -image-size 1500M -dev snowball_emmc -boot 2 -system 2 -userdata 2 If you only want to be able to boot from the SD card and don't care aboutīooting from the eMMC (internal flash), the quick solution is to do: $ minicom -D /dev/ttyUSB0 -w -C minicom.txtĭuring the 12.05 cycle, U-Boot changed and must be upgraded in eMMC if yourīoot line is older than: U-boot 2012.04.01 (19:50:12) Plug in an USB-to-serial converter and run minicom Remove the SD card from the device writer and plug it into the board. $ dconf write /org/gnome/desktop/media-handling/automount-open $TMP2 $ dconf write /org/gnome/desktop/media-handling/automount $TMP1 ![]() $ linaro-android-media-create -mmc /dev/sdc -dev snowball_sd -boot 2 -system 2 -userdata 2 You can erase your hard drive with the wrong parameter. Finding out what version of OSMC you are on. WARNING: In the next step, make sure you use /dev/"whatever you see above". xml file that specify a part of a file path that will get replaced, and the new path that will be replacing it. Free, secure and fast open source software downloads from the largest open source applications and software directory. Look for a line that looks like the following at the end of the log $ dconf write /org/gnome/desktop/media-handling/automount-open false $ dconf write /org/gnome/desktop/media-handling/automount false $ TMP2=$(dconf read /org/gnome/desktop/media-handling/automount-open) $ TMP1=$(dconf read /org/gnome/desktop/media-handling/automount) $ sudo apt-get install linaro-image-toolsĭisable automount (instructions provided for Gnome) $ sudo add-apt-repository ppa:linaro-maintainers/tools Run these commands to get all the dependencies for linaro-image-tools
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |